1-RAİN BİRD
 - Rotorlar
 - Damlama sulama
 - Dekoder Sistemleri
 - Kontrol Sistemleri
 - Kontrol Üniteleri
 - Merkezi Kontrol Sistemleri
 - Pompa İstasyonları
 - Spreyler
 - Uydu Sistemleri
 - Vanalar
1- RAİN BİRD
2-HUNTER
3-K-RAİN/ORBİT/BACCA
4-NELSON
5-OTTOMAN IRRIGATION
6-ESEN PLASTİK
7-SUYAP COUPLING

sulama videolari, sulama görüntüleri, sulama dökümanları

sulama iletişim, sulama hizmetleri, sulama şirketleri

sulama videolari, sulama görüntüleri sulama iletisim
Ana Sayfa > 1-RAİN BİRD > V-SERIES PUMP STATION Fiyat : 0.00 $


Büyük Resim
V-SERIES PUMP STATION Fiyat : 0.00 $



Malzeme Özellikleri :
UYGULAMA

V-3100 series, the economy line
Standard configuration has 2 or 3 pumps. Available flow range up to 200 m3/h.
Standard features include:
• Grundfos CR Vertical multistage centrifugal pumps.
• Closed type motors, IP44, 3Ph, 400/690V, 50Hz, 2950rpm.
• Galvanized steel base frame.
• Galvanized steel suction and discharge manifolds.
• Isolation valve for each pump.
• Check valve for each pump.
• Protective thermostat on each pump prevents motor from running too hot.
• Pressure transmitter in stainless steel.
• Hose point connection.
• Touch-button user interface shows actual operating conditions and alarms and allows for easy pressure setting adjustment.

V-3200 series. The most commonly used line that is suitable for most golf course applications. Standard configuration has 2 to 5 pumps. Available flow range up to 500 m3/h.
Additional standard features include:
• Flow meter with electronic signal to the Control Cabinet. Allows maximum flow setting. In the event of this threshold being exceeded (for example a pipe burst) the pumps will automatically shut down.
• Automatic self-flushing cast-iron Y-strainer (mesh size 1,5mm) with PLC-controlled
Over Pressure Relief valve. Screen is automatically flushed each time pump starts.
• Main Isolation valve on pump station outlet.
• Jockey pump included for pump sizes CR64 and larger.
• Advanced touch-button user interface shows actual water flow, operating conditions and alarms and allows for easy pressure setting adjustment.

V-3300 series, The high end line. Standard configuration has 2 to 5 pumps. Available flow range up to 500 m3/h.
Additional standard features include:
• Independent Over Pressure Relief Valve.
• Jockey pump included for pump sizes CR45 and larger.
• Water-cooled heat exchanger on the control cabinet.
• RBSv Pump Manager software with modems.
• 3-phase failure control checks incoming power supply for over/under voltage and phase loss reversal.
• Heat sensors on motors.
• Floating low water level switch.
• State of the art color Touch-screen user interface shows actual operating conditions and alarms.



GENEL ÖZELLIKLER

Testing
All Rain Bird pump stations undergo rigorous quality during manufacturing. This includes operating the completely assembled pump station at its designed capacity to ensure that it is fully calibrated.
Variable speed control
All Rain Bird pump stations use electronic Variable Speed technology. Variable Speed Controlled pump sets maintain a constant pressure against variable flow. Variable Speed Control provides a smooth automated start and stop of the pump station and an extremely quiet, low vibration operation.

All models use the same Variable Frequency Drive technology and all cabinets have the same basic design and standard components. This allows the use of RBSv Pump Manager (Standard in V-3300) and Smart Pump in all models.

Remote control from your PC through RBSweden Pump Manager Software
The RBSweden Pump Manager software offers the possibility to remotely control the pump station from a PC. The pump station is connected to the irrigation PC with Rain Bird 2x2,5mm2 cable and two modems or via radio communication. This also allows for troubleshooting of the pump station from a remote location.

The possibility to direct link your Pump Station to your Central Control system through Smart PumpTM
This exclusive software module available with Rain Bird Stratus LT, StratusII, NimbusII and Cirrus Central Control systems allows you to link your Rain Bird pump station directly with the irrigation Central Control system. Monitors and graphs both actual and controlled flow. Direct and real-time communication between the pump station and the Irrigation Central optimizes your irrigation cycle by adjusting flow demand according to actual field conditions.

AKSESUARLAR
The following options are available
Flow-meter for V-3100
Flow-meter with signal to the cabinet.
Isolation valves
Extra butterfly valves mounted on the suction side of the pumps. Main discharge butterfly valve on the V-3100 series.
Jockey Pump
A Jockey pump may be installed on the frame or in some cases supplied as a submersible unit. This pump will supply low water demands, for example when a hose is used or a single rotor is started manually, without a large pump having to start. Recommended for the larger stations. Jockey pumps are standard in the V-3200 series from CR64 pumps and standard in the V-3300 series from CR45 pumps.
Independent pressure relief valve
A Y-strainer with automatic flushing and PLC-controlled over pressure relief valve is standard on V-3200 and V-3300 series pump stations. For additional protection a pilot operated diaphragm type pressure relief valve may be installed as an option.
Low water lever switch
Floating water level switch with 10m cable.
Suction Parts
Suction parts include foot valve, quick coupling or flanged connection and drain valve. PE pipe is not included.
Priming Pump
A Grundfos priming pump model JP5 may be incorporated in the pump set, fitted with a manually operated three way valve, to prime the pump set following winter drain-down.
Prime maintenance
This option consists of a pressure regulating valve fitted on a bypass from the pump station discharge connected to the suction manifold to maintain pressure on the foot valve.
Stainless Steel
Both suction and discharge manifolds can be supplied in Stainless Steel, when aggressive water has to be used.
Pressure vessel
A pressure vessel may be installed either on the frame or as a stand-alone unit.
Z-pipe
A Z-pipe for connection between the Pump Station and the irrigation main line can be supplied. Customized pipe with two 45° elbows, DIN flanges on both ends all in galvanized steel.
Control cabinet cooling
A water-cooled heat exchanger can be mounted on the control cabinet. A heat exchanger should be installed in areas where the temperature may exceed 40°C.
RBSweden Pump Manager Software
The RBSweden Pump Manager software offers the possibility to remotely control the pump station from a PC. The pump station is connected to the irrigation PC with
Rain Bird 2x2,5mm2 cable and two modems or via radio communication.
Lightning protection for Pump Manager
Over-Voltage suppressor for communication cable and power supply at both PC and the Pump Station.
Rotating Screen Control
Output for solenoid to rotating intake screen. 3-Phase failure control
This unit checks the incoming power supply for over-/under voltage and phase loss or reversal.
Heating element
In colder climates a 3kW heating element may supplied.
Heat sensors on motors
Protect and shut off the motor before overheating.
Soft starter
Soft starter instead of Y/D starter.